Reasons and methods of use of glass edging machine

The reasons for the defects of the glass edging machine and the method of use. The glass glass edging machine is one of the earliest and the largest amount of cold processing equipment in the deep processing equipment of glass machinery. It is mainly suitable for the processing of furniture glass, architectural glass and craft glass, and is mainly used for grinding and polishing the bottom edge and chamfer of ordinary flat glass. Next, let’s talk about how to solve the problems of the glass glass edging machine's bad causes and operation methods?

1. Reasons for the glass edging machine:

1. It is possible that the glass edging machine, grinding and polishing method, cooling method, and speed are not selected well.

2. The technical level of the operator will also affect the product

Second, the method of use and operation steps:

1. For all kinds of newly purchased edging Please read the instruction manual before using the machine. After understanding the transmission principle of the machine, the functions of various handles, handwheels, electrical buttons, waterway and airway regulating valves, and mastering the knowledge of machine maintenance, you can operate on the machine.

2. The quality of the grinding head of the edging machine has a great influence on the grinding quality of the glass. The position of the grinding head and the moving gap have been adjusted before leaving the factory, except for the advance and retreat grinding heads. , The rest generally do not move, so as not to affect the grinding quality. In addition, the retreat position of the grinding head is not easy to be too large, otherwise the waterproof cover will be easily damaged, causing water leakage and burning the motor.

3. Adequate cooling also has a greater impact on the grinding effect. Always check whether the cooling pipeline is blocked. Especially the pipeline of the linear glass edging machine is easy to be blocked by the bristles, and it is not easy to be noticed after blocking, which will cause insufficient cooling and affect the quality of edging.

4. The continuously variable transmission used by the edging machine must be in the open state when adjusting the speed, otherwise it is easy to damage the continuously variable transmission of the edging machine.