Precautions for using glass washing machine

The physical principle of the glass glass edging machine is that after the transducer converts high-frequency electrical energy into mechanical energy, it will generate high-frequency vibration with very small amplitude and spread to the solution in the cleaning tank. Under the action of the transducer, the interior of the cleaning fluid will continuously produce a large number of tiny bubbles and burst instantly. The burst of each bubble will generate a shock wave of hundreds of degrees of high temperature and nearly a thousand atmospheres, thereby washing the workpiece clean. The advent of the glass washing machine provides convenience for special equipment for cleaning and drying the glass surface in the pre-processes of deep processing processes such as mirror making, vacuum coating, tempering, hot bending, and hollow glass lamination. Then you should pay attention to the use of glass washing machine:

1. Since the glass washing machine is operated by buttons, please pay attention to turn on the blower first, and then turn on the heater. Turn off the heater first, then turn off the blower. We must not forget this sequence.

2. When the glass washing machine stops the motor, the speed regulator must be reset to zero, or unnecessary trouble will occur.

3. The glass discharge of the glass washing machine is regular, and it must be discharged within the specified limit.

4. There is an emergency stop button on the motor of the glass washing machine, which can be used in emergency situations. Do not touch it normally.

5. When the thickness of the glass plate of the glass washing machine changes, the height of the air knife must be adjusted in time, or unnecessary damage accidents may occur.

6. When the glass edging machine enters the water, the water level is controlled between 200-250mm, and water cannot be added at high or low positions.

The above are the precautions for using the glass washing machine. I hope to help you again.