(+86)757-27756688

Manufacturer maintenance glass edge grinding machine knowledge points

by:Enkong     2021-04-22
Manufacturer on glass edge grinding machine maintenance knowledge points, glass edge grinding machine is in use for a period of time after the need for regular maintenance, to ensure that the glass edge grinding effect, can ensure the long-term stability of the machine can work at the same time. Specific how should for maintenance, what's the key points of operation, the manufacturer will give everybody to explain about the glass edge grinding machine of knowledge points. 1. When using supply circulating water tank, a day after processing, please replace the JiaGongShui, lest the tank caused by dirt inside the pipe plug. 2. In water, please pull the plug, and then take out the water tank, pour out waste water, and cleaning tank and filter powder detergent. 3. Tanks in processing resin, can produce a large number of bubbles. Replacing JiaGongShui, add defoaming agent, 7 ~ 10 times. Defoaming agent to eliminate plastic bubble. When the bubble much more special, can be pointed directly at bubble jet 2 ~ 3 times, stir after the effect is much better. 4. The clean water. Water-jet once congestion, reduced or no water, resulting in processing ability to reduce or even unable to work. The water jet cleaning, please unplug the nozzle, with fine needle to remove the nozzle internal plugs. 5. Clean edge grinding writers water cover. To work long hours, can make the lens cutting dust attached on the waterproof cover, if not timely cleaning, cutting dust will be cured, it is difficult to remove. Observe the line of sight. Processing after the end of each day, please clean with brush and water containers. 6. Clean edge grinding chamber. Processing for a long time, can make the jaw axis, clamp and cutting edge grinding indoor wall adherent dust, if not keep clear of in time, will scratch the lens, will cause the clamping piece shaft sealing ring wear lead to head into the water. The cleaning method has the following two kinds: ( 1) Clean with brush and water spray container directly. ( 2) Into the clean pattern cleaning machine. This method can also clean the machine internal water supply line. Specific steps, please refer to the random with operating instructions. 7. Clean edge grinding machine and scanner shell. After every day with the machine, must be clean immediately. If put a few days again after cleaning, cutting powder curing on the chassis, will be difficult to remove. Please use soft cloth with neutral detergent to clean shell. 8. Dressing grinding wheel. After the grinding wheel dull, processing time. To resume the performance of grinding wheel, should trim ( After about 1000 pieces of glass grinding) 。 9. To move up and down by support bar head edge grinding machine, also can be in the support bar a little clock lubricating oil regularly. Manufacturer of above is for everyone to explain about the maintenance of glass edge grinding machine operation method, you learned today? To better ensure the quality of the glass edge grinding machine processing, improve work efficiency, guarantee later use effect, still hope the broad masses of customers in the later use well for maintenance.
is frequently used by people in daily life since it can improve glass machine manufacturer and glass processing machines.
All of the experts Guangdong Enkong Machinery Co.,Ltd. consulted stressed that the best recovery plans are the ones made before you need them, not afterward.
Guangdong Enkong Machinery Co.,Ltd. always focus on the situation of global market and understands the importance factors of manufacturing glass machine.
Though the cost of these sustainability initiatives as glass machine can be high, harnessing the power of an ethical supply chain to appeal to conscientious consumers can be a smart move both ethically and financially.
Custom message
Chat Online
Chat Online
Leave Your Message inputting...