(+86)757-27756688

Glass machinery manufacturer about how to maintain the glass edge grinding machine

by:Enkong     2021-05-26
Glass edge grinding machine is in use for a period of time after the need for regular maintenance, to ensure that the glass edge grinding effect, can ensure the long-term stability of the machine can work at the same time. Edge grinding machine maintenance is mainly is to clean the edge grinding module, lubrication support bar, etc. Let's look at together: 1. When using supply circulating water tank, a day after processing, please replace the JiaGongShui, lest the tank caused by dirt inside the pipe plug. 2. In water, please pull the plug, and then take out the water tank, pour out waste water, and cleaning tank and filter powder detergent. 3. Tanks in processing resin, can produce a large number of bubbles. Replacing JiaGongShui, add defoaming agent, 7 ~ 10 times. Defoaming agent to eliminate plastic bubble. When the bubble much more special, can be pointed directly at bubble jet 2 ~ 3 times, stir after the effect is much better. 4. The clean water. Water-jet once congestion, reduced or no water, resulting in processing ability to reduce or even unable to work. The water jet cleaning, please unplug the nozzle, with fine needle to remove the nozzle internal plugs. 5. Clean edge grinding writers water cover. To work long hours, can make the lens cutting dust attached on the waterproof cover, if not timely cleaning, cutting dust will be cured, it is difficult to remove. Observe the line of sight. Processing after the end of each day, please clean with brush and water containers. 6. Clean edge grinding chamber. Processing for a long time, can make the jaw axis, clamp and cutting edge grinding indoor wall adherent dust, if not keep clear of in time, will scratch the lens, will cause the clamping piece shaft sealing ring wear lead to head into the water. The cleaning method has the following two kinds: ( 1) Clean with brush and water spray container directly. ( 2) Into the clean pattern cleaning machine. This method can also clean the machine internal water supply line. Specific steps, please refer to the random with operating instructions. 7. Clean edge grinding machine and scanner shell. After every day with the machine, must be clean immediately. If put a few days again after cleaning, cutting powder curing on the chassis, will be difficult to remove. Please use soft cloth with neutral detergent to clean shell. 8. Dressing grinding wheel. After the grinding wheel dull, processing time. To resume the performance of grinding wheel, should trim ( After about 1000 pieces of glass grinding) 。 9. To move up and down by support bar head edge grinding machine, also can be in the support bar a little clock lubricating oil regularly.
Custom message
Chat Online
Chat Online
Leave Your Message inputting...