English

(+86)757-27756688

Glass six straight edge machine common processing method

by:Enkong     2021-05-30
Glass six common several ways of dealing with a straight edge machine, horizontal uneven ( Grinding of glass with the size of the head) Machines in use after a period of time, if there is a level, the reasons are: 1, the soft foundation. Without cement concrete foundation can not bear the weight of the host itself, make host sinking, result in uneven. Need to consolidate foundation, cushion flat to the fuselage. 2, glass bracket foot has no fixed. When grinding large glass is easy to produce displacement, has led to the difference of level. Need to correction stents. 3, use the machine for a long time only replace the small conveyor chain block glue, the old and new square plastic use collocation, height difference, has led to the head size of grinding out of glass. Must replace all square glue or simply change the whole picture of conveyor chain. 4, conveyor chain level uneven. Into a head of conveyor chain and a glass a conveyor chain and front and back platen is not a straight line ( Don't level) 。 A guide rail height (first tune into glass Can guide at the bottom of the stroke by adjusting screw screw) , make the long glass edge grinding at 2500 can from beginning to end on the guide of conveyor chain transmission ( In glass into the pressure plate after 40 cm watch two places: press the plate at the bottom of the glass and machines on the conveyor chain whether most the right side of the glass on the conveyor chain or stick on the conveyor chain) , if the pressure plate at the bottom of the glass on the conveyor chain conveyor chain and leave empty, would probably have to lower the A word on the shelf right guide rail travel screw until smooth; If the machine is most the right side of the glass on the conveyor chain cock tail ( Empty) , you will need to rise to the right A word on the shelf of the guide screw until smooth. Machine on the left side of the conveyor chain adjustment levels can also according to the principles of reasoning. Second, the end or the middle can't polishing head to tail after polishing mainly into the glass head bone line of sprockets produced displacement, resulting in glass forward shift. First apart two head machine set, for the glass that the first two sprockets height and Angle correction, will be subject to two sprockets to eye gear box. Before and after the middle can't polishing or polishing is not good: linking piece too loose, glass sink phenomenon frequently in grinding, and lead to glass grinding quantity too much, to produce the middle can't polishing or polishing. As long as open chassis fastening plate chain.
Custom message
Chat Online
Chat Online
Chat Online inputting...